The mixture of different natural materials with resins such as polyurethane and epoxy casting gives a perfectly smooth ground and many advantages:
      * - Huge selection of colors and finishes beautifully crafted
      * - For use on all surfaces and most floor coverings
      * - Working corners and edges very easily
      * - Particularly easy maintenance: fully waterproof, nonporous and do not hang dust
Betonflame retains the appearance of a concrete floor but contains none of the disadvantages of this type of soil. It finished in layers of 10cm thickness, cracks, irregularities, and dirt.

Implementation

First phase:
See technical preparation of the support.
Beware, the moisture content of the device can not exceed 2.5%!

Second phase: (porous)
Mix well the components A and B Primary 103 S using a mixer until a homogeneous mass.
Application by roller or squeegee with a layer of primary BETONFLAME. Consumption concrete 250-300gr g / m²; screed 300-450gr / m².
Polymerization: approximately 6 hours at +20 ° C. Polymerisation in dry is imperative.

Third phase: (on tile, not all soil levels etc..)
Mix well the components A and B until a homogeneous mass BETONFLAME Levelling using a mixer.
Add the load (component C) and mix until a homogeneous mass.
Polymerization: approximately 6 hours at +20 ° C. Polymerisation in dry is imperative.
Application using a trowel, avoids aeration after 10 minutes.
Consumption 2-3 kg / m²

Fourth phase:
Establish the BETONFLAME "VERSION Flame" or "VERSION KINGDOM.

Mix well the components A and B BETONFLAM using a mixer until a homogeneous mass.
Add up and mix again until a homogeneous mass.
Polymerization: approximately 6 hours at +20 ° C. Polymerisation in dry is imperative.
Application using a trowel, a trowel or a regulated adjustable special resin, after 10 minutes with a roller débuler débuleur.

Consumption 3.50 kg / m² for 2 mm

Fifth phase:
Apply a top coat (optional)
Clean tools in Solvent MEK

Map colors